How to Test Humidity Steam Sensor?
CP Support Team
Sep-1st, 2017 13:41

  1. Disconnect sensor connector from power control board.

  2. With ohm scale on multimeter, measure resistance terminal to terminal.

Normal Results:

Black-Red Wires =  5.3Kohm~6.2Kohm

Red-White Wires =  2.7Kohm~3.1Kohm

Black-White Wires = 2.7Kohm~3.1Kohm

Sensor Cooking Condition:

  1. Oven should be plugged in at least 5 min before sensor cooking.
  2. Room temperature should not exceed 95F
  3. Oven Cabinet and the exterior of the cooking container must be dry.
  4. The microwave will not generate energy for the first 26 seconds of the sensor cooking cycle. 
Was this article helpful?
1 out of 1 found this helpful
Leave a comment

 Diagnostic Tips